Use the “msh> set bonjour” command to display and configure authentication exclusion control settings.
View Settings
msh> authfree
If print job authentication exclusion is not set, authentication exclusion control cannot be displayed.
IPv4 address settings
msh> authfree "ID" range_addr1 range_addr2
IPv6 address settings
msh> authfree "ID" range6_addr1 range6_addr2
IPv6 address mask settings
msh> authfree "ID" mask6_addr1 masklen
Parallel/USB settings
msh> authfree [parallel|usb] [on|off]
To enable authfree, set to "on". To disable authfree, set to "off".
Always specify the interface.
Authentication exclusion control initialization
msh> authfree flush
For IPv4 and IPv6, up to five access ranges can be registered and selected.