Using NetWare
This section describes the setting procedure for network printers in the NetWare environment. In the NetWare environment, you can connect the machine as a “print server” or “remote printer”.
IPv6 cannnot be used on this function.
Setting procedure
When using the machine as a print server
Installing SmartDeviceMonitor for Admin
Setting the network interface board.
Turning the machine off and then back on.
When using the machine as a remote printer
Installing SmartDeviceMonitor for Admin.
Setting the network interface board.
Setting NetWare.
Starting the print server.
This procedure assumes an environment is already prepared for normal NetWare running the printing service setting.
The procedure is explained with the following example settings:
File server's name ...CAREE
Print server's name ...PSERV
Printer's name ...R-PRN
Queue name ...R-QUEUE
Using SmartDeviceMonitor for Admin
To use the machine in a NetWare environment, use SmartDeviceMonitor for Admin to set the NetWare printing environment.
The NetWare Client provided by Novell is required to set the printing environment using SmartDeviceMonitor for Admin under the following environments:
NDS mode in Windows 95/98/Me
NDS or Bindery mode in Windows 2000/XP, Windows NT 4.0
Printers listed by SmartDeviceMonitor for Admin
SmartDeviceMonitor for Admin lists printers connected to the network. If you cannot identify the machine you want to configure, print configuration page, and then check the machine name.
