Interrupt Copy
Use this function if you want to interrupt a long copy job to make urgently needed copies.
You cannot use the Interrupt Copy function when fax originals are being scanned or the scanner function is being used.
Press the [Interrupt] key.
The machine stops scanning. Remove the originals that were being copied.
Place the originals you want to copy.
Press the [Start] key.
The machine starts making copies.
When copying is complete, remove the originals and copies.
Press the [Interrupt] key again.
The interrupt key indicator goes off.
Replace the originals that you were copying, and then press the [Start] key.
Following message “Reset n originals.”, replace the originals that you were copying.
The previous copy job settings are restored. Simply press the [Start] key to continue copying from where it left off.
